Home› AOMEI Products Support

PE Builder and NTPWEdit snap-in tool

klingardklingard
in AOMEI Products Support
Hi,
  I searched for the NTPWEdit snap-in tool in my PE Builder environment
  but could not find it.
   Does anyone knowhow to access this tool ?

Thanks

Comments

  • adminadmin
    Hello Klingard,
    Did you create WinPE bootable media via AOMEI PE Builder and add the NTPWEdit snap-in tool to the WinPE?
    What version of NTPWEdit snap-in tool did you add? portable version？
  • klingardklingard
    Hi,
     Yes I created WinPE bootable media via AOMEI PE Builder. 
      No I did not add the NTPWEdit snap-in tool to the WinPE.

      How do I  add the NTPWEdit snap-in tool to the WinPE.

    Thanks,
    klingard
  • klingardklingard
    Hi,
       However, I did manage to access the NTPWedit tool by using the
       file explorer to locate a version on my C drive when I tested the PE  
       builder in the recovery environment.
       However I was unable to use it as an error message was displayed
       concerning "it would be dangerous to access files due to hibernation".
       Is there a solution to this issue ?

    Thanks,
    klingard

  • adminadmin
    Hi Klingard,
    The NTPWedit tool only supports running under 32bit WinPE. You need to create 32bit Winpe, then the tool will be integrated into Winpe. 
  • klingardklingard
    Hi,

      OK - Thank you for your help. I will create a 32 bit WinPE.
Sign In or Register to comment.