Home› AOMEI Products Support

Disk clone does not recognize source drive (system disk)

gheijkgheijk
edited September 2014 in AOMEI Products Support

Hi All,

Since yesterday I tried to clone my current HDD as this drive has some bad sectors and I want to replace it. This is a 500GB drive that will be replaced by a 750GB HDD. I wanted to use Disk clone for this, but when selecting the source my current 500GB is not listed there.

image
In Computer management both drives are recognized. See below.

image
The copy drive I created using partition clone, but this gives me error "0xc000000f -- The boot selection failed because a required device is inaccessible" when I start up the system using the copied drive.

That is why I want to use Disk clone to see if that can make it work.

Do you guys have any suggestions for this problem? Or maybe suggestions on how to get the 0xc000000f error resolved?

Many thanks!

Comments

  • adminadmin

    Your source disk is dynamic disk. Please convert it to basic disk using AOMEI Dynamic Disk Converter before you clone it to other disk.

Sign In or Register to comment.