Main Threads:Recently did copy partition wizard, from ide to sata/ata hardrive all went well but.....
  • Hello everyone,

    First of all i want to say....im not the most cpu savy person.

     I recently did a copy partion wizard from a IDE hardrive to a Sata/ata hardrive, all was completed perfectly but when i disconnected the IDE hardrive and restarted the computer just with the new hardrive it doesn't load, it goes to a black screen with one line on the top left side blinking and it doest go past that, the os system never loads just stays on that .... =[  

    If i connect the other drive it loads the os system perfectly, an on the computer it shows the new drive with all the files.


    This is what it shown on the hard disk drives window.


    Local Disk (C:)  (IDE Drive)

    12.6 MB free of 19.9 GB

    Local Disk (E:) 

    2.34 GB free of 2.38 GB

    Local Disk (G:)

    444 GB free of 463 GB


    ps. IDE Drive (the one the os system is on) has only about 10mb-50mb free all the time. 

    (Low Disk Notification appears every 5 min) tried deleting programs, doing a clean to the drive and also a defrag but the drive stays on 10-50mb.


    Cpu specs:

    Asus M34A88T-M motherboard

    Maxtor 20gb IDE hardrive 

    Seagate Barracuda 500gb Sata/ata


    If someone can help me out i would really be gratefull !!!

    Thank you very much for taking your time to read this.

  • Thank you very much for the quick reply really appreciate it.


    Just looked over to try and fix and it seems i did use Disk Copy Wizard. 


    I went and looked at the disks and i found on the E disk it has a folder named boot and inside the folder are these folders.

    Local Disk (E:) 

    2.34 GB free of 2.38 GB

    image

  • Hi Jay,


    Could you please try rebuild MBR, please refer to this link: http://www.disk-partition.com/help/rebuilt-MBR.html


    Best Regards,

    Ted

Start a New Discussion

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!