Home AOMEI Products Support

PE Builder 1.5 Error RAID 0 Intel RST 14.6

I am try to build a Win PE to include RAID drivers Intel RST 14.6 on a Win 7 Pro 64 bit. The Win PE builds, and loads to error driver viaide.sys missing. There are no ide harddrives on the computer though viaide.sys does exist on the computer C:\Windows\System32\drivers and two other locations.


Would installing Windows 7 ADK solve this problem?


Also in your further notes to using Aomei Win PEbuilder:

"For instance, to make Windows PE can recognize your RAID hard disk, you
can add RAID controller driver to Windows PE. However, you should make
sure that the driver kit is complete before adding it to Windows PE and
select the right INF installation file. Otherwise, the hardware cannot
run though added successfully."


"driver kit is complete" is confusing. The Win PEbuilder add driver only allows for .inf of which there are two iaAHCIC.inf and iaStorAC.inf, but there are other files that are not .inf in installing Intel RST 14.6. Can the PE run the intel RAID only on these two .inf files? How can I add the other files if they are need.


Thanks,

Mark

Comments

  • Ok no response so far. Can someone at Aomei at least tell me what they mean by "driver kit is complete" in the Win PEbuilder instructions? "Driver kit" comes across as something more than just driver?

  • Sorry for the late reply.

    " and loads to error driver viaide.sys missing."

    Hope you can give us the screenshot of this problem.

    "Would installing Windows 7 ADK solve this problem?"

    There is no need to add it again.

    "Can the PE run the intel RAID only on these two .inf files?"

    Normally, it can run with the .inf files.You can try it.

    Our software jsut can add the .inf file.

Sign In or Register to comment.